Pro Stripper

How do I apply Goof Off® Semi Paste Pro Stripper for best results?

Apply it thick, and only brush in one direction. This prevents the thickener in the stripper from getting too torn up, so the product doesn’t evaporate away before softening the finish. Give the stripper time to work, at least 15 minutes, before test scraping it. If the finish is ready to come off, scrape it off, moving any damp stripper to the next area to be stripped. Then wipe the stripped surface down with mineral spirits or paint thinner to remove any residue.


Goof Off® Semi Paste Pro Stripper dried on my surface, what should I do?

Reapply the stripper liberally and let it stand 15 to 30 minutes. The stripper will soften up the dried stripper and the stripping project can continue.


What temperature’s are best to use Goof Off® Semi Paste Pro Stripper?

Between 65-85 degrees Fahrenheit are best. Any temperature above or below this window and the stripper will work slower.


Is the Goof Off® Semi Paste Pro Stripper flammable?

No.


No. Is it safe to use Goof Off® Semi Paste Pro Stripper on fiberglass?

No, this stripper is strong enough that it can severely damage fiberglass.


What type of brush should be used to apply stripper?

Use inexpensive natural bristle brushes that can be disposed of afterward.


How should Goof Off® Semi Paste All Purpose Stripper be applied?

In a thick coat with a single brush stroke. Strippers contain ingredients to retard evaporation. Excess brushing causes loss of the active ingredients, causing the stripper to dry out. For safety reasons, keep the work area small and manageable (no more than 9 sq. ft. area).


Can I use the Goof Off® Semi Paste All Purpose Stripper near a pilot light?

No, this stripper is flammable, and shouldn’t be used near any open flame or source or spark.